Matrix FWD L4-2.4L (2AZ-FE) (2009)
/Page-1678008.png)
(d) Put tread center marks on the rearmost points of the front wheels and measure the distance between the marks (dimension B).
(e) Slowly push the vehicle straight ahead to rotate the front wheels 180° using the front tire valve as a reference point.
HINT: Do not allow the wheels to rotate more than 180°. If the wheels rotate more than 180°, perform the procedure from *1 again.
(f) Measure the distance between the tread center marks on the front side of the wheels (dimension A).
Toe-in (Unloaded Vehicle):
HINT:
-
Measure "B - A" only when "C + D" cannot be measured.
-
If the toe-in is not within the specified range, adjust it at the rack ends.
7. ADJUST TOE-IN
(a) Make sure that the lengths of the right and left rack ends are almost the same.
Standard difference:
1.5 mm (0.0591 in.) or less
