Matrix XRS 2WD L4-1.8L (2ZZ-GE) (2003)
/Page-641003.png)
h. Using a screwdriver, disconnect the control cable from the shift lever plate.
i.
Remove the 2 bolts.
j.
Pull out the control cable assy from the body.
k. Remove the retainer from the shift cable.
14. INSTALL FLOOR SHIFT CABLE TRANSMISSION CONTROL SHIFT
a. Install the retainer to the shift cable.
b. Pull in the control cable assy to the body.
c. Install the 2 bolts.
Torque: 5.0 Nm (50 kgf-cm, 43 inch lbs.)
d. Install the control cable to the shift lever plate.
e. Connect the control cable end to the floor shift assy.
