MR2 L4-132 2164cc 2.2L DOHC (5S-FE) (1993)
/Page-450003.png)
-
Temporarily install the 2 bolts holding the delivery pipe to the cylinder head.
-
Check that the injectors rotate smoothly.
HINT: If injectors do not rotate smoothly, the probable cause is incorrect installation of 0-rings. Replace the 0-rings.
-
Position the injector connector upward.
-
Tighten the 2 bolts holding the delivery pipe to the cylinder head.
Torque: 13 Nm (9 ft.lb)
-
Connect the 4 injector connectors.
2. CONNECT FUEL INLET PIPE AND RETURN HOSE.
-
Connect the fuel inlet pipe to the delivery pipe with 2 new gaskets and the pulsation damper.
Torque: 34 Nm (25 ft.lb)
-
Connect the fuel return hose.
-
Install the fuel inlet pipe to the cylinder head with the bolt.
3. INSTALL ENGINE WIRE PROTECTOR.
