Paseo L4-1497cc 1.5L DOHC (5E-FE) (1992)
Torque: 12 N.m (120 kgf.cm. 9 ft.lbf)
(c) Tighten the pivot nut and through bolt.
Torque: 41 N.m (420 kgf.cm, 30 ft.lbf)
(d) Check the belt tension.
B. Without A/C: Adjust PS pump drive belt
(a) Loosen the bolts A and B.
(b) Tighten the bolt B. pushing up the PS pump with the pump bracket lower end as fulcrum.
Torque: 39 N.m (400 kgf.cm. 29 ft.lbf)
(c) Tighten the bolt A.
Torque: 43 N.m (440 kgf.cm, 32 ft.lbf)
(d) Check the belt tension.
C. With A/C: Adjust PS pump drive belt
(a) Loosen the bolts A and B.
(b) Loosen the lock nuts D and E.
(c) Adjust the adjusting bolt F so that its protrusion above nut C is + 0 mm (0 in.).
(d) Fix nut C using lock nut D.
(e) Turn the adjusting bolt F to push up the pump and adjust the belt tension to the specified value.
(f) Tighten the bolts A and B.
Torque:
43 N.m (440 kgf.cm, 32 ft.lbf) for Bolt A
39 N.m (400 kgf.cm, 29 ft.lbf) for Bolt B
(g) Loosen the adjusting bolt F by 4 or 5 turns.
NOTICE: Check that there is a gap of 5 mm (0.20 in.) or more between the tip of the nut C and the PS pump body.
(h) Fix the adjusting bolt F with the lock nut E.
(i) Check the belt tension.