toyota Workshop Repair Guides

Toyota Workshop Service and Repair Manuals

Condenser HVAC|Testing and Inspection|Page 5297 > < Condenser HVAC|Testing and Inspection
Page 1
background image

Condenser HVAC: Service and Repair

CONDENSER REMOVAL

1. DISCHARGE REFRIGERANT FROM REFRIGERATION SYSTEM

INSTALLATION HINT:  Evacuate air from refrigeration system.

See: Service and Repair/Discharging & Evacuating System

Charge system with refrigerant and inspect for leakage of refrigerant.

See: Service and Repair/Charging the System

Specified amount:

600 ± 50 g (21.16 ± 1.76 oz.)

2. REMOVE THESE PARTS:

a. Radiator upper seal.
b. Radiator upper mountings.
c. Air cleaner duct.
d. Engine coolant reservoir tank.
e. Receiver and holder. See: Receiver Dryer/Service and Repair

3.  DISCONNECT LIQUID TUBE AND DISCHARGE HOSE

Remove the 2 bolts and tube and hose.

Torque: 5.4 N.m (55 kgf.cm, 48 in.lbf)

REMOVAL NOTE:  Cap the open fittings Immediately to keep moisture or dirt out of the system.

INSTALLATION HINT:  Lubricate 2 new O-rings with compressor oil and install the tubes.

4. REMOVE CONDENSER

Condenser HVAC|Testing and Inspection|Page 5297 > < Condenser HVAC|Testing and Inspection