Paseo Coupe L4-1497cc 1.5L DOHC MFI (1997)
Receiver Dryer: Service and Repair
RECEIVER REMOVAL
1. DISCHARGE REFRIGERANT FROM REFRIGERATION SYSTEM
INSTALLATION HINT: Evacuate air from refrigeration system.
See: Service and Repair/Discharging & Evacuating System
Charge system with refrigerant and inspect for leakage of refrigerant.
See: Service and Repair/Charging the System
Specified amount:
600 ± 50 g (21.16 ± 1.70 oz.)
2. REMOVE RADIATOR UPPER SEAL
3. DISCONNECT 2 LIQUID TUBES FROM RECEIVER
Remove the 2 bolts and both tubes.
Torque: 5.4 N.m (55 kgf.cm, 48 in.lbf)
REMOVAL NOTE: Cap the open fittings immediately to keep moisture dirt out of the system.
INSTALLATION HINT: Lubricate 2 new O-rings with compressor oil and install the tubes.
4. REMOVE RECEIVER
Remove the holder bolt and pull the receiver upward from the receiver holder.
INSTALLATION HINT: If receiver was replaced, add compressor oil to compressor.
Add 10 cc (0.4 fl.oz.)
Compressor oil:
ND-OIL 8 or equivalent
5. REMOVE RECEIVER HOLDER
Remove the bolt and holder.
RECEIVER INSTALLATION
Installation is in the reverse order of removal.