Paseo Coupe L4-1497cc 1.5L DOHC MFI (1997)
c. Using the 09616 - 00010 SST to stop the control valve shaft rotating, tighten a new nut to 59 Nm (43 ft. lbs.).
11. Install the rack housing cap, doing the following.
a. Apply Part No.08833 - 00080, THREE BOND 1344, LOCTITE 242 or equivalent sealant to 2 or 3 threads of the cap.
b. Tighten the cap to 59 Nm (43 ft. lbs.).
c. Using a punch and a hammer, stake the cap at two places.
12. Install the rack guide seat, rack guide, rack guide spring, and rack guide spring cap by doing the following.
a. Install the seat to the guide.
b. Install the guide to the rack housing.
c. Apply Part No.08833 - 00080. THREE BOND 1344, LOCTITE 242 or equivalent sealant to 2 or 3 threads of the spring cap.
d. Temporarily install the cap.
13. Adjust the total preload, following these procedures.
a. To prevent the steering rack teeth from damaging the oil seal lip, temporarily install the right and left hand rack ends.
b. Using a (21 mm) hexagon wrench , tighten the rack guide spring cap to 25 Nm (18 ft. lbs.).
c. Using a (21 mm) hexagon wrench, return the cap 12°.
d. Using the 09616 - 00010 SST, turn the control valve shaft right and left 1 or 2 times.
e. Using a (21 mm) hexagon wrench, loosen the cap until the rack guide spring is not functioning.
