Pickup 4WD L4-2366cc 2.4L SOHC (22R) (1984)
/Page-751001.png)
Wiper Motor: Technical Service Bulletins
Instruments - Wiper Motor Circuit Breaker Inspection
REF.: ELECTRICAL
NO.: EL95-004
DATE: NOVEMBER 10, 1995
MODEL: ALL MODELS
WIPER MOTOR CIRCUIT BREAKER INSPECTION PROCEDURE
To eliminate the possibility of Wiper Motor damage, all ND Wiper Motors are equipped with circuit breaker protection.
This circuit breaker is a thermal limiting type and will reset automatically after the Wiper Motor current load returns to normal.
REPRESENTATIVE LOCATION OF CIRCUIT BREAKER:
INSPECTION PROCEDURE:
^
Inspect the Wiper Fuse.
^
Verify there is power and ground to the Wiper Motor on all speeds (including "Intermittent" or "Mist" if applicable).
After verifying power and ground to the Wiper Motor, follow the procedure below to prevent unnecessary Wiper Motor replacement because of a
temporary open in the Wiper Motor Circuit Breaker.
1)
Disconnect the Wiper Motor Harness Connector.
2)
Wait (10) minutes before checking continuity.
3)
Check the continuity of the motor with an ohmmeter.
If there is no continuity in the Wiper Motor after 10 minutes, replace the Wiper Motor.
REPRESENTATIVE CHECKING PROCEDURE:
