Prius L4-1.8L (2ZR-FXE) Hybrid (2010)
HINT
The mark plate on the crankshaft side is colored pink.
12. CHECK NO. 1 CYLINDER TO TDC/COMPRESSION
(a) Check each timing mark at TDC/compression.
13. INSTALL NO. 2 CHAIN VIBRATION DAMPER
(a) Install the No. 2 chain vibration damper with the 2 bolts.
Torque : 10 Nm (102 kgf-cm, 7 ft-lbf)
14. INSTALL CHAIN TENSIONER SLIPPER
(a) Install the chain tensioner slipper to the cylinder block.
15. INSTALL TIMING CHAIN COVER OIL SEAL See: Engine Lubrication/Oil Pump/Service and Repair/Removal and Replacement/Installation
16. INSTALL TIMING CHAIN COVER SUB-ASSEMBLY See: Engine Lubrication/Oil Pump/Service and Repair/Removal and
Replacement/Installation
17. INSTALL CRANKSHAFT PULLEY See: Seals and Gaskets/Front Crankshaft Seal/Service and Repair/Installation
18. INSTALL NO. 1 CHAIN TENSIONER ASSEMBLY
(a) Release the cam, and then fully push in the plunger and engage the hook to the pin so that the plunger is in the position shown in the
illustration.