toyota Workshop Repair Guides

Toyota Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 3335 > < Initial Inspection and Diagnostic Overview|Page 3333
Page 79
background image

Text in Illustration

Result:

B --  CHECK FOR SHORT TO GND IN CAN BUS WIRE (ECU, SENSOR)

A --  REPLACE CAN NO. 2 JUNCTION CONNECTOR

3. CHECK FOR SHORT TO GND IN CAN BUS WIRE (CAN NO. 1 J/C)

(a) Disconnect the CAN No. 1 junction connector.

Text in Illustration

(b) Measure the resistance according to the value(s) in the table below.

Initial Inspection and Diagnostic Overview|Page 3335 > < Initial Inspection and Diagnostic Overview|Page 3333