RAV4 2WD L4-2.5L (2AR-FE) (2009)
/Page-1454001.png)
Brake Master Cylinder: Testing and Inspection
On-Vehicle Inspection
BRAKE: BRAKE MASTER CYLINDER: ON-VEHICLE INSPECTION
ON-VEHICLE INSPECTION
1. CHECK BRAKE FLUID LEVEL WARNING SWITCH
(a) Remove the reservoir filler cap and strainer.
(b) Disconnect the brake fluid level warning switch connector.
(c) Measure the resistance according to the value(s) in the table below.
HINT: There is a float inside the reservoir. Its position can be changed by increasing or decreasing the brake fluid level.
Standard Resistance:
If the result is not as specified, replace the brake master cylinder reservoir sub-assembly.
(d) Add brake fluid to the MAX level.
