RAV4 4-Door 4WD L4-2.0L (3S-FE) (1997)
/Page-1638004.png)
2. Install PS vane pump assembly with pump bracket. Torque the 3 bolts.
Torque: 43 Nm (32 ft. lbs.)
3. Connect pressure feed tube. Using SST, connect the tube.
SST 09631 - 22020
Torque: 36 Nm (26 ft. lbs.)
HINT:
^
Use a torque wrench with a fulcrum length of 300 mm (11.81 inch)
^
This torque value is effective in case that SST is parallel to a torque wrench.
4. Install drive belt.
a. Adjust drive belt tension.
b. Torque the 3 bolts.
Torque: 43 Nm (32 ft. lbs.)
5. Connect return hose.
6. Connect 2 vacuum hoses.
7. Connect 2 tube clamps. Torque the bolt.
Torque: 13 Nm (9 ft. lbs.)
8. Install front suspension crossmember assembly.
9. Torque 2 PS gear assembly set bolts and nuts.
Torque: 113 Nm (83 ft. lbs.)
10. Connect RH and LH lower suspension arms.
11. Install stabilizer bar with link.
12. Install front exhaust pipe.
