RAV4 4-Door 4WD L4-2.0L (3S-FE) (1997)
8. Disconnect 2 vacuum hoses.
9. Disconnect return hose.
NOTICE: Take care not to spill fluid on the drive belt.
10. Remove drive belt. Loosen the 2 bolts.
11. Disconnect pressure feed tub. Using Special Service Tool (SST), disconnect the tube.
SST 09631 - 22020
12. Remove PS vane pump assembly with pump bracket. Remove the 3 bolts.
13. Remove pressure feed tube. Remove the union bolt, gasket and tube from the PS vane pump assembly.
INSTALLATION
1. Install pressure feed tube. Torque the union bolt over a new gasket.
Torque: 51 Nm (38 ft. lbs.)
HINT: Make sure the tube is touching the stopper of the pressure feed No.2 tube, as shown, then torque the union bolt.