Sequoia 2WD V8-4.6L (1UR-FE) (2010)
/Page-763001.png)
Tire Pressure Warning Reset Switch: Service and Repair
Removal
TIRE PRESSURE MONITORING: TIRE PRESSURE WARNING RESET SWITCH: REMOVAL
1. REMOVE FRONT DOOR SCUFF PLATE LH See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Removal
2. REMOVE COWL SIDE TRIM BOARD LH See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Removal
3. REMOVE INSTRUMENT SIDE PANEL LH See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Removal
4. REMOVE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY See: Body and Frame/Doors, Hood and Trunk/Hood/Hood Latch Release
Cable/Service and Repair/Removal
5. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH See: Body and Frame/Interior Moulding / Trim/Dashboard
/ Instrument Panel/Service and Repair/Removal
6. REMOVE TIRE PRESSURE WARNING RESET SWITCH
(a) Disengage the 2 claws and remove the tire pressure warning reset switch from the lower instrument panel finish panel sub-assembly LH.
