Sequoia 2WD V8-4.6L (1UR-FE) (2010)
Throttle Body: Service and Repair
Removal
1UR-FE ENGINE CONTROL: THROTTLE BODY: REMOVAL
1. REMOVE NO. 1 ENGINE UNDER COVER See: Engine, Cooling and Exhaust/Engine/Engine Lubrication/Engine Oil/Service and
Repair/Replacement
2. DRAIN ENGINE COOLANT See: Engine, Cooling and Exhaust/Cooling System/Coolant/Service and Repair
3. REMOVE V-BANK COVER SUB-ASSEMBLY See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and
Replacement/Engine Assembly/Removal
4. REMOVE AIR CLEANER HOSE ASSEMBLY See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and
Replacement/Engine Assembly/Removal
5. REMOVE THROTTLE BODY ASSEMBLY
(a) Disconnect the 2 water by-pass hoses.
(b) Disconnect the throttle position sensor and control motor connector.
(c) Remove the 4 bolts, throttle body and gasket.
(d) Remove the No. 12 water by-pass hose from the throttle body.
(e) Remove the No. 4 water by-pass hose from the throttle body.