Sequoia 2WD V8-4.6L (1UR-FE) (2010)
Throttle Body: Service and Repair
Installation
1UR-FE ENGINE CONTROL: THROTTLE BODY: INSTALLATION
1. INSTALL THROTTLE BODY ASSEMBLY
(a) Install the No. 4 water by-pass hose to the throttle body.
HINT
When installing the hose, make sure the paint mark and clip are as shown in the illustration.
(b) Install the No. 12 water by-pass hose to the throttle body.
HINT
When installing the hose, make sure the paint mark and clip are as shown in the illustration.
(c) Install a new gasket to the intake air surge tank.
HINT
Align the protrusion of the gasket with the groove of the intake air surge tank.
(d) Install the throttle body with the 4 bolts.
Torque : 10 Nm (102 kgf-cm, 7 ft-lbf)
(e) Connect the throttle position sensor and control motor connector.