Sienna AWD V6-3.3L (3MZ-FE) (2004)
/Page-449001.png)
Intake Manifold: Specifications
INSTALL INTAKE MANIFOLD
Install the intake manifold with the 9 bolts and the 2 nuts. Using several steps, tighten the bolts and the nuts uniformly in the sequence shown in the
illustration.
Retighten the 2 bolts and 2 nuts of the water outlet.
Torque ....................................................................................................................................................................... 15 Nm (153 kgf-cm, 11 ft. lbs.)
Retighten the water outlet mounting bolts and nuts.
Torque ........................................................................................................................................................................ 15 Nm (153 kgf-cm, 11 ft. lbs.)
Install the ground cable with the nut.
Torque ..................................................................................................................................................................... 8.4 Nm (86 kgf-cm, 74 inch lbs.)
Connect the heater water inlet hose B
