Sienna AWD V6-3.5L (2GR-FE) (2007)
/Page-1042011.png)
17. REMOVE FRONT DRIVE SHAFT BEARING
(a)
Using SST and a press, remove the front drive shaft bearing.
SST 09527-10011
INSPECTION
1. INSPECT FRONT DRIVE SHAFT ASSEMBLY LH
(a)
Check that there is no remarkable play in the radial direction of the outboard joint.
(b) Check that the inboard joint slides smoothly in the thrust direction.
(c)
Check that there is no remarkable play in the radial direction of the inboard joint.
(d) Check the boots for damage.
(e)
For dimension (A), refer to the following table.
REASSEMBLY
