Sienna AWD V6-3.5L (2GR-FE) (2007)
1. INSTALL FRONT DRIVE SHAFT BEARING
(a)
Using SST and a press, install a new front drive shaft bearing.
SST 09710-30021 (09710-03141), 09527-10011
NOTICE: Bearing should be completely installed.
2. INSTALL FRONT DRIVE SHAFT RH HOLE SNAP RING
(a)
Using a snap ring expander, install a new front drive shaft RH hole snap ring.
3. INSTALL FRONT DRIVE SHAFT DUST COVER
(a)
Using SST and a press, install a new drive shaft dust cover until the distance from the tip of the center drive shaft to the drive shaft dust cover
meets the specification, as shown in the illustration.
SST 09726-40010, 09527-10011
Distance (A): 26.8 to 27.4 mm (1.0551 to 1.0787 inch)
4. INSTALL FRONT DRIVE SHAFT DUST COVER RH (for 2WD)
(a)
Using SST and a press, install a new drive shaft dust cover RH until the distance from the tip of the center drive shaft to the drive shaft dust
cover RH meets the specification, as shown in the illustration.