Tundra 2WD V6-3.4L (5VZ-FE) (2004)
a. Remove the rear floor anchor belt cover and bolt.
b. Using a screwdriver, remove the clip labeled A, 3 clips labeled B and pillar garnish.
HINT: Tape the screwdriver tip before use.
23. REMOVE QUARTER TRIM PANEL LOWER RH
HINT: Use the same procedures described for the RH side.
24. REMOVE QUARTER TRIM BOARD LH
a. Remove the shoulder anchor bolt.
b. Using a screwdriver, remove the 2 clips and bolt.
HINT: Tape the screwdriver tip before use.
25. REMOVE QUARTER TRIM BOARD RH
HINT: Use the same procedures described for the RH side.
26. REMOVE DOME LIGHT
a. Using a screwdriver, remove the lens.
HINT: Tape the screwdriver tip before use.
b. Remove the 2 screws and dome light, then disconnect the connector.
27. BACK PANEL TRIM