Tundra 2WD V6-3.4L (5VZ-FE) (2004)
/Page-931001.png)
Vacuum Brake Booster: Service and Repair
Double Cab
BRAKE BOOSTER ASSEMBLY (Double Cab)
REMOVAL
NOTICE:
^
Do not adjust the brake booster push rod.
^
Do not change the combination of the diameter converting unit and brake.
1. REMOVE MASTER CYLINDER
2. DISCONNECT VACUUM HOSE FROM BRAKE BOOSTER
3. REMOVE SCUFF PLATE LH, COWL SIDE TRIM LH, LOWER FINISH PANEL AND NO. 2 HEATER TO REGISTER DUCT
4. REMOVE PEDAL RETURN SPRING
5. REMOVE CLIP AND CLEVIS PIN
6. REMOVE BRAKE BOOSTER
a. Remove the 4 nuts and clevis.
b. Pull out the brake booster and gasket.
c. Remove the 2 stopper rings, brake booster bracket and gasket from the brake booster.
INSTALLATION
1. INSTALL BRAKE BOOSTER
a. Install a new gasket to the brake booster.
b. Install the brake booster bracket and 2 stopper rings to the brake booster.
c. Install the booster and a new gasket.
