Tundra 2WD V6-3.4L (5VZ-FE) (2004)
d. Install the clevis to the operating rod.
e. Install and torque the booster installation nuts.
Torque: 13 Nm (130 kgf-cm, 9 ft. lbs.)
f.
Install the clevis pin into the clevis and brake pedal, and install the clip to the clevis pin.
g. Connect the vacuum hose to the brake booster.
2. INSTALL NO. 2 HEATER TO REGISTER DUCT, LOWER FINISH PANEL, COWL SIDE TRIM LH AND SCUFF PLATE
NOTICE:
^
Do not adjust the brake booster push rod.
^
Do not change the combination of the diameter converting unit and brake.
3. INSTALL MASTER CYLINDER
4. FILL BRAKE RESERVOIR WITH BRAKE FLUID AND BLEED BRAKE SYSTEM
5. CHECK FOR FLUID LEAKAGE
6. CHECK AND ADJUST BRAKE PEDAL
7. DO OPERATIONAL CHECK