Tundra 2WD V6-3.4L (5VZ-FE) (2004)
10. REMOVE SENSOR ROTOR AND KEY
a. Remove the sensor rotor and key.
b. Using a snap ring expander, remove the snap ring.
11. INSTALL SENSOR ROTOR AND KEY
a. Using a snap ring expander, install the snap ring.
b. Install the key and sensor rotor.
12. 5VZ-FE: INSTALL SPEEDOMETER DRIVE GEAR AND BALL
a. Install the speedometer drive gear and ball.
b. Using a snap ring expander, install the snap ring.
13. 2UZ-FE: INSTALL SPEEDOMETER DRIVE GEAR
a. Install the speedometer drive gear.
b. Using a snap ring expander, install the snap ring.
14. INSTALL EXTENSION HOUSING AND GASKET
a. Apply sealant or equivalent to the 6 bolt threads.
Sealant: Part No. 08833-00080, THREE BOND 1344, LOCTITE 242 or equivalent
b. Install the extension housing with a new gasket to the case.
c. Install the 6 bolts.
Torque: 36 Nm (370 kgf-cm, 27 ft. lbs.)
HINT: The 2 lower bolts are shorter.
15. INSTALL ENGINE REAR MOUNTING INSULATOR TO EXTENSION HOUSING
Install the engine rear mounting insulator with the 4 bolts.
Torque: 65 Nm (660 kgf-cm, 48 ft. lbs.)