Tundra 2WD V6-3.4L (5VZ-FE) (2004)
16. INSTALL CROSSMEMBER
a. Install the crossmember with the 4 washers, bolts and nuts.
Torque: 72 Nm (734 kgf-cm, 53 ft. lbs.)
b. Install the 4 bolts on the rear mounting side to the engine rear mounting insulator.
Torque: 18 Nm (185 kgf-cm, 13 ft. lbs.)
17. INSTALL NO. 2 VEHICLE SPEED SENSOR
18. INSTALL SPEEDOMETER DRIVEN GEAR AND NO. 1 VEHICLE SPEED SENSOR
19. INSTALL PROPELLER SHAFT
20. FILL ATF AND CHECK FLUID LEVEL