Tundra 2WD V6-3.4L (5VZ-FE) (2004)
c. Using a chisel and hammer, tap out the outer tubes.
d. Using SST and a press, install 2 new bushings.
SST 09710-28012 (09710-07062), 09710-30041 (09710-03211)
2. REPLACE LEAF SPRING
a. Bend to open the spring clips.
Using a chisel and hammer, pry up the 2 spring clips.
b. Remove the center bolt and nut.
Hold the spring near the spring center bolt in a vise and remove the center bolt and nut.
c. Replace the spring clip.
1) Drill off the head of the rivet and drive it out.
2) Install a new rivet into the holes of the spring leaf and clip. Then rivet with a press.
d. Install spring center bolt and nut.
1) Align the leaf spring holes and secure the leaves with a vise.
2) Install the spring center bolt and nut.
Torque: 44 Nm (450 kgf-cm, 33 ft. lbs.)