Tundra Regular Cab SR5 4WD V8-4.7L (2UZ-FE) (2000)
c. Push piano wire through from the interior.
d. Tie both wire ends to wooden blocks or similar objects.
HINT: Apply protective tape to the outer surface to keep the surface from being scratched.
NOTE: When separating the glass, take care not to damage the paint and exterior.
e. Cut the adhesive by pulling the piano wire around it.
HINT: Cut the adhesive areas as shown in the illustration, leaving the adhesive where the stud bolts are.
f.
Let the piano wire pass as shown in the illustration, cut off the adhered part to the stud bolts.
g. Remove the glass.
NOTE: Leave as much of the adhesive on the body as possible when cutting off the glass.
INSTALLATION
HINT: For step 8 to 17, refer to Headliner.
1. CLEAN AND SHAPE CONTACT SURFACE OF BODY