Van Wagon 2WD L4-2237cc 22L (4Y-E) (1989) - Lower Suspension Arm (Page 1953)
Control Arm: Service and Repair
Lower Suspension Arm & Shock Absorber
Fig. 11 Exploded View Of Front Suspension Components. 4WD
W/4WD
1.
Disconnect shock absorber and stabilizer bar from lower suspension arm, Fig. 11.
2.
Remove lower ball joint cotter pin and nut, then using suitable puller, separate lower suspension arm from ball joint.
3.
Mark relative position between front and rear adjusting cams, then remove attaching nut, adjusting cams and lower suspension arm.
4.
Reverse procedure to install. Torque lower suspension arm to ball joint nut, stabilizer bar attaching bolts and shock absorber to lower suspension
arm bracket to specifications. Lower vehicle to ground, then bounce vehicle several times to stabilize vehicle and torque adjusting cam nuts to
specification with suspension loaded.