Venza AWD V6-3.5L (2GR-FE) (2010)
HINT
This garnish needs to be replaced with a new one because the clip will break when removing the door frame garnish.
10. REMOVE DOOR SIDE AIRBAG SENSOR See: Restraint Systems/Air Bag Systems/Impact Sensor/Service and Repair/Side Airbag Sensor (for
Front Side)/Removal
11. REMOVE FRONT NO. 1 SPEAKER ASSEMBLY See: Accessories and Optional Equipment/Radio, Stereo, and Compact Disc/Speaker/Service
and Repair/Front Door Speaker/Removal
12. REMOVE FRONT DOOR SERVICE HOLE COVER
(a) Disengage the clamp.
(b) Remove the bolt.
(c) Remove the front door service hole cover.
HINT
Remove any remaining butyl tape from the door.
13. REMOVE OUTER REAR VIEW MIRROR ASSEMBLY See: Mirrors/Service and Repair/Outer Rear View Mirror/Removal
14. REMOVE FRONT DOOR GLASS SUB-ASSEMBLY
(a) Connect the cable to the negative (-) battery terminal.
(b) Connect the power window regulator master switch assembly and move the front door glass sub-assembly so that the door glass bolts can be
seen.
(c) Disconnect the cable from the negative (-) battery terminal and power window regulator master switch assembly.
(d) Remove the 2 bolts.
NOTICE:
After the bolts are removed, do not allow the door glass to fall.
(e) Remove the front door glass sub-assembly as indicated by the arrows, in the order shown in the illustration.