Venza AWD V6-3.5L (2GR-FE) (2010)
(f) Connect the connector.
34. INSTALL FRONT DOOR GLASS SUB-ASSEMBLY
(a) Connect the cable to the negative (-) battery terminal.
(b) Connect the power window regulator master switch assembly and move the front door glass sub-assembly so that the door glass bolts can be
seen.
(c) Disconnect the cable from the negative (-) battery terminal and power window regulator master switch assembly.
(d) Insert the front door glass sub-assembly into the front door panel along the front door glass run as indicated by the arrows, in the order shown
in the illustration.
(e) Install the front door glass sub-assembly with the 2 bolts.
Torque : 8.0 Nm (82 kgf-cm, 71 in-lbf)
35. INSTALL OUTER REAR VIEW MIRROR ASSEMBLY See: Mirrors/Service and Repair/Outer Rear View Mirror/Installation
36. INSTALL FRONT DOOR SERVICE HOLE COVER
(a) Apply butyl tape to the front door panel.
(b) Pass the front door lock remote control cable assembly and front door inside locking cable assembly through a new front door service hole
cover.