Venza AWD V6-3.5L (2GR-FE) (2010)
HINT
*
Use the same procedure for the LH side and RH side.
*
The following procedure is for the LH side.
*
If the sensor rotor needs to be replaced, replace it together with the front drive shaft assembly.
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected See: Testing and
Inspection/Programming and Relearning/Repair Instruction - Initialization.
2. REMOVE FRONT WHEEL
3. REMOVE FRONT FENDER OUTSIDE MOULDING LH See: Body and Frame/Spoilers, Flaps, and Air Dams/Mud Flap/Service and
Repair/Removal
4. REMOVE FRONT FENDER LINER LH See: Body and Frame/Doors, Hood and Trunk/Hood/Hood Latch Release Cable/Service and
Repair/Removal
5. REMOVE FRONT SPEED SENSOR
(a) Disconnect the front speed sensor connector and remove the 2 clamps.
(b) Remove the bolt and No. 2 sensor clamp from the body.
Text in Illustration
(c) Remove the bolt, No. 1 sensor clamp and flexible hose together from the shock absorber assembly.
Text in Illustration