Venza AWD V6-3.5L (2GR-FE) (2010)
/Page-1476003.png)
(d) Remove the bolt, resin clamp and front speed sensor.
NOTICE:
*
Prevent foreign matter from attaching to the front speed sensor tip.
*
Clean the speed sensor installation hole and the contact surfaces every time the front speed sensor is removed.
Text in Illustration
Installation
BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: FRONT SPEED SENSOR: INSTALLATION
HINT
*
Use the same procedure for the LH side and RH side.
*
The following procedure is for the LH side.
*
If the sensor rotor needs to be replaced, replace it together with the front drive shaft assembly.
1. INSTALL FRONT SPEED SENSOR
(a) Install the resin clamp and front speed sensor with the bolt.
Torque : 8.0 Nm (82 kgf-cm, 71 in-lbf)
NOTICE:
*
Prevent foreign matter from attaching to the front speed sensor tip.
*
Firmly insert the front speed sensor body into the knuckle before tightening the bolt.
*
After installing the front speed sensor to the knuckle, make sure that there is no clearance between the front speed sensor stay and
knuckle. Also make sure that no foreign matter is stuck between the parts.
