Venza AWD V6-3.5L (2GR-FE) (2010)
Exhaust Manifold: Service and Repair
Installation
2GR-FE INTAKE / EXHAUST: EXHAUST MANIFOLD: INSTALLATION
1. INSTALL EXHAUST MANIFOLD TO HEAD GASKET LH
(a) Install a new exhaust manifold to head gasket LH.
2. INSTALL EXHAUST MANIFOLD SUB-ASSEMBLY LH
(a) Using a 12 mm deep socket wrench, install the exhaust manifold sub-assembly LH and 6 nuts in the order shown in the illustration.
Torque : 21 Nm (214 kgf-cm, 15 ft-lbf)
3. INSTALL NO. 2 EXHAUST MANIFOLD HEAT INSULATOR
(a) Install the No. 2 exhaust manifold heat insulator with the 3 bolts.
Torque : 8.5 Nm (87 kgf-cm, 75 in-lbf)
4. INSTALL NO. 2 OIL LEVEL DIPSTICK GUIDE
(a) Install a new O-ring to the No. 2 oil level dipstick guide.
(b) Apply a light coat of engine oil to the O-ring.