Venza AWD V6-3.5L (2GR-FE) (2010)
Removal
DRIVE SHAFT / PROPELLER SHAFT: REAR DRIVE SHAFT ASSEMBLY (for AWD): REMOVAL
HINT
*
Use the same procedure for the LH side and RH side.
*
The following procedure listed below is for the LH side.
1. REMOVE REAR WHEEL
2. SEPARATE REAR SPEED SENSOR See: Wheel Hub/Service and Repair/Rear Axle Hub/Removal
3. REMOVE REAR AXLE SHAFT NUT
(a) Using SST and a hammer, release the staked part of the rear axle shaft nut.