Venza AWD V6-3.5L (2GR-FE) (2010)
SST : 09930-00010
NOTICE:
Loosen the staked part of the nut completely, otherwise the threads of the drive shaft may be damaged.
(b) While applying the brakes, remove the rear axle shaft nut.
4. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY See: Brakes and Traction Control/Parking Brake System/Service and
Repair/Disassembly
5. REMOVE REAR DISC See: Brakes and Traction Control/Disc Brake System/Service and Repair/Rear Brake/Removal
6. REMOVE REAR AXLE HUB AND BEARING ASSEMBLY See: Wheel Hub/Service and Repair/Rear Axle Hub/Removal
7. SEPARATE NO. 3 PARKING BRAKE CABLE ASSEMBLY See: Steering and Suspension/Suspension/Trailing Arm/Service and
Repair/Removal
8. REMOVE REAR STRUT ROD ASSEMBLY See: Steering and Suspension/Suspension/Trailing Arm/Service and Repair/Removal
9. REMOVE REAR AXLE CARRIER SUB-ASSEMBLY See: Steering and Suspension/Suspension/Rear Knuckle/Service and Repair/Removal
10. REMOVE REAR DRIVE SHAFT ASSEMBLY
(a) Using SST, remove the rear drive shaft assembly as shown in the illustration.
SST : 09520-01010
SST : 09520-24010
09520-32040
NOTICE:
Remove the rear drive shaft assembly while keeping it level.
Installation
DRIVE SHAFT / PROPELLER SHAFT: REAR DRIVE SHAFT ASSEMBLY (for AWD): INSTALLATION
1. INSTALL REAR DRIVE SHAFT ASSEMBLY
(a) Align the shaft splines and install the rear drive shaft assembly using a screwdriver and hammer.