Venza FWD L4-2.7L (1AR-FE) (2009)
/Page-128001.png)
Steering Control Module: Service and Repair
Installation
POWER ASSIST SYSTEMS: POWER STEERING ECU: INSTALLATION
INSTALLATION
1. INSTALL POWER STEERING ECU ASSEMBLY
(a) Engage the 4 wire harness clamps to the power steering ECU assembly.
(b) Install the power steering ECU assembly with the 3 nuts.
Torque: 14 Nm (138 kgf-cm, 10ft-lbf)
(c) Securely connect the connector to the power steering ECU assembly.
HINT: Return the lock lever to its original position to connect the connector, and then securely push in the lock of the lock lever as shown in
the illustration.
