Oil Feed and Oil Return Lines (Oil Cooler), Remove and Install (X 17 DTL)
Remove, Disconnect
Remove front panelling - see operation "Front Panelling, Remove and Install" in group "A".
Remove banjo bolts (1) - collect escaping engine oil.
Remove fastening bolts (1) and remove oil line bracket (2).
Loosen union nuts (1) on oil cooler - collect escaping engine oil. Remove oil feed and return lines.
Install, Connect
Insert oil feed and return lines and fasten with union nuts - 30 Nm/22 lbf. ft.
Fasten oil line bracket with oil lines to side member.
Insert banjo bolts with new seal rings and fasten oil feed and return lines to oil cooler adapter - 30 Nm/22 lbf. ft.
Install front panelling - see operation "Front Panelling, Remove and Install" in group "A".
Inspect
Check engine oil level and correct if necessary.
Remove, Disconnect 
Install, Connect 
Inspect 