Anti-theft Warning System ATWS System
Modification F7:PROGRAMMING
PROGRAMMING
COUNTRY CODE
Conditions for Checking
Nominal Value
Affected terminals: -
Possible trouble codes: -
Ignition ON
Press key F7 in the system main
menu, select the desired test using the arrow keys and confirm with YES.
Follow the instructions in the TECH 1 display.
Start programming
After the programming is
started, the country code to be programmed is required. There is a choice
between the following countries:
· Germany (or Europe, except for the
countries mentioned below) "D"
· Great Britain "GB"
· Switzerland "CH"
· Netherlands "NL"
GERMANY
GR.
BRITAIN
SWITZERLAND
NETHERLANDS
If the display on the right
appears after programming, programming was successful.
PROGRAMMING
COUNTRY
CODE
OKAY
If the display on the right
appears after programming, a fault has occurred during programming. The
following actions should be taken consecutively:
· Read trouble code; no trouble code may
be stored;
· Repeat programming;
· Perform TECH 1 self-test;
· Check TECH 1 cable for damaged
insulation and shielding;