Astra F
Immobiliser with Transponder Immobiliser Control Unit, Remove and Install Important! If the immobiliser control unit is being replaced, it must be reprogrammed - see corresponding Checking Procedures. Notice: Because of the different versions of the ignition lock housing, there are two different assembly procedures. In the case of spare parts control equipment - immobilisers without clips can be exchanged for control units with clips. For control units with clips new ignition lock apertures are necessary. These can also be used with control units without clips.
Remove, Disconnect
Install, Connect
Possibility 2: Ignition lock housing with clips Remove, Disconnect
|
||||||