Replace bonnet locking mechanism Bowden cable
(RHD)
Remove
1. |
Detach Bowden cable from bonnet closure
• |
Detach Bowden cable (3) from bonnet closure (4)
|
|
|
|
2. |
Slightly loosen engine compartment wind protection panelling
(2)
|
3. |
Release rubber grommet (1) from bulkhead
|
|
|
4. |
Detach lower inner panelling of instrument panel padding on
driver's side
|
5. |
Detach bonnet locking mechanism actuating lever
• |
Unclip lever assembly from bracket (in direction of arrow)
|
|
6. |
Detach bonnet locking mechanism Bowden cable
Note: Pull Bowden cable
out towards interior of vehicle.
|
|
|
Install
7. |
Attach bonnet locking mechanism Bowden cable
• |
Pull the Bowden cable through the bulkhead towards the engine
compartment
|
|
8. |
Attach bonnet locking mechanism actuating lever
• |
Clip the actuating lever assembly into the bracket
|
|
9. |
Attach the bulkhead grommet
|
10. |
Attach lower inner panelling of instrument panel padding on
driver's side
|
11. |
Attach engine compartment wind protection panelling seal
|
12. |
Route Bowden cable
Note: Make sure that it
has no kinks.
|
13. |
Attach Bowden cable to bonnet closure
• |
Attach Bowden cable to bonnet locking mechanism
|
|
14. |
Adjust Bowden cable
Note: Adjust Bowden
cable so that there is no clearance where the end nipple rests
against the bonnet closure.
• |
The bonnet closure must return to its initial position after
actuation from any setting.
|
|
|