Result
|
Cause Of Fault
|
E001
|
Result: System Overload
|
- A temporary current overload in the system behind fuse F54 has occurred
Note:
In case of a temporary current overload, the cause for the blow of the fuse may be located in a circuit behind the control unit/component.
These circuits should be checked additionally for short to ground.
|
|
E002
|
Result: Defective Component
|
- If the nominal value is reached during one of the measurements, the component/control unit that has been disconnected immediately before that measurement is defective.
Note:
If the defective component is a control unit, the cause for the fault may be located in a circuit behind that component.
These circuits should be checked additionally for short to ground.
|
|
E003
|
Result: Short to Ground
|
- Short circuit to ground between:
F54 Fuse Output contact & M10D Motor - Window Lifter, Driver Door Wiring harness connector (wiring harness side) terminal 1 & M10P Motor - Window Lifter, Front Passenger Door Wiring harness connector (wiring harness side) terminal 1
|
|