vauxhall Workshop Repair Guides

Vauxhall Workshop Service and Repair Manuals

C-071 Fuse FE29 Circuit > < C-069 Fuse FE27 Circuit

C-070 - Fuse FE28 Circuit

Test

Work Order Description

Nominal Value

T001

Check: Short to Ground of Voltage Supply Circuit

  • Ignition OFF
  • Reconnect all disconnected components
  • All consumers turned off
  • Insert new component:
    FE28 Fuse
  • Ignition ON
  • Check the following component for proper operation:
    FE28 Fuse

Test okay?

Yes: No:
T002

Check: Vehicle Configuration

Is the following information correct for the actual vehicle?

Astra-H, Front Wheel Drive, Automatic Transmission, AF 22-4
Astra-H, Front Wheel Drive, Automatic Transmission, AF 17-4
Yes: No:
T003

Check: Short to Ground of Voltage Supply Circuit

  • Ignition OFF
  • Disconnect wiring harness connector from:
    A112 Control Unit - Transmission
  • Ignition ON
  • Insert new fuse FE28 and then check the fuse for proper operation.

Test okay?

Yes: No:
T004

Check: Vehicle Configuration

Is the following information correct for the actual vehicle?

Front Wheel Drive, Manual-Transmission-Automatic (Easytronic) M20-6MTA/M32-6MTA
Yes: No:
T005

Check: Short to Ground of Voltage Supply Circuit

  • Ignition OFF
  • Disconnect wiring harness connector from:
    A112 Control Unit - Transmission
    (Wiring Harness Connector XC82 )
  • Ignition ON
  • Insert new fuse FE28 and then check the fuse for proper operation.

Test okay?

Yes: No:
T006

Check: Vehicle Configuration

Is the following information correct for the actual vehicle?

Front Wheel Drive, Automatic Transmission, AF 40-6
Yes: No:
T007

Check: Short to Ground of Voltage Supply Circuit

  • Ignition OFF
  • Disconnect wiring harness connector from:
    A112 Control Unit - Transmission
    (Wiring Harness Connector XC60 )
  • Ignition ON
  • Insert new fuse FE28 and then check the fuse for proper operation.
  • Disconnect each of the following components/control units consecutively from the wiring harness and repeat the check each time:
    S22A Assembly Unit - Selector Lever

Test okay?

Yes: No:


Result

Cause Of Fault

E001 Result: System Overload
  • A temporary current overload in the system behind fuse FE28 has occurred

Note:

In case of a temporary current overload, the cause for the blow of the fuse may be located in a circuit behind the control unit/component.

These circuits should be checked additionally for short to ground.

E002 Result: Defective Component
  • Defective component:
    A112 Control Unit - Transmission

Important:

Reset the concerned control unit with the diagnostic tester before replacing it. In order to do that, call up the "RESET" function from the PROGRAMMING menu of the current system on the diagnostic tester.

Note:

If the defective component is a control unit, the cause for the fault may be located in a circuit behind that component.

E003 Result: Short to Ground
  • Short circuit to ground between:
    X125 Underhood Electronic Module
    Socket Terminal 19 (XE3)
    &
    Wiring harness connector terminals of all components (wiring harness side), which were disconnected from the wiring harness during this troubleshooting session

or

  • Defective component:
    X125 Underhood Electronic Module

Important:

Reset the concerned control unit with the diagnostic tester before replacing it. In order to do that, call up the "RESET" function from the PROGRAMMING menu of the current system on the diagnostic tester.

E004 Result: Defective Component
  • If the nominal value is reached during one of the measurements, the component/control unit that has been disconnected immediately before that measurement is defective.

Important:

Reset the concerned control unit with the diagnostic tester before replacing it. In order to do that, call up the "RESET" function from the PROGRAMMING menu of the current system on the diagnostic tester.

Note:

If the defective component is a control unit, the cause for the fault may be located in a circuit behind that component.






C-071 Fuse FE29 Circuit > < C-069 Fuse FE27 Circuit