|
Brake Anchor Plate – Rear Wheel Brake,
Remove and Install
 Remove
| 1. |
Top up brake fluid reservoir to "MAX" marking and seal with
MKM-558-10
|
| 4. |
Remove brake shoes of the rear wheel brake 
|
| 5. |
Remove wheel brake cylinder (1)
|
| 6. |
Detach retaining clip (4) and remove parking brake cable (3)
from brake anchor plate
|
| 7. |
Detach wheel bearing unit (2) with brake anchor plate from rear
axle
|
|
|
Install
| 8. |
Attach brake anchor plate to rear axle with wheel bearing unit
|
| 9. |
Insert parking brake cable in brake anchor plate and attach new
retaining clip.
|
| 10. |
Install wheel brake cylinder
|
| 11. |
Install brake shoes on rear wheel brake
|
| 13. |
Fit rear wheel 110 Nm
|
| 14. |
Bleed brake system and check for leaks
|
| 15. |
Actuate brake pedal repeatedly
|
| 16. |
Top up brake fluid to "MAX" mark
|
|
