|
Engine does not start, starter slow / does not turn
|
The following test steps must be performed in the given order. If a fault is found in one test step, the subsequent test steps can be skipped.
Fuse
- Check the following fuses for proper operation:
FE18 Fuse
- If fuse FE18 is defective:
Data List
- Select the following Functional System on the diagnostic tester:
Electronic Diesel Injection System DECE1C, A 17 DTJ, A 17 DTR, Z 17 DTJ, Z 17 DTR
Diesel Particulate Filter
Only if one of the above listed systems is installed, check the following parameters for correct function:
- Check the following data list parameters:
-
Perform the following troubleshooting:
After successful test/fault repair proceed to the next test step
|
|
Engine does not start, starter runs normal
|
The following test steps must be performed in the given order. If a fault is found in one test step, the subsequent test steps can be skipped.
Function Checks
Data List
- Select the following Functional System on the diagnostic tester:
Electronic Diesel Injection System DECE1C, A 17 DTJ, A 17 DTR, Z 17 DTJ, Z 17 DTR
- Check the following data list parameters:
The check of the following system is only necessary, if the outside temperature is less than 0 °C (32 °F).
Actuator Tests
- Perform the following Actuator Tests:
Glow Time Relay Test
- If the test fails, perform the following test step:
After successful test/fault repair proceed to the next test step
|
|
Engine starts poorly, starter runs normal
|
The following test steps must be performed in the given order. If a fault is found in one test step, the subsequent test steps can be skipped.
Function Checks
Data List
- Select the following Functional System on the diagnostic tester:
Electronic Diesel Injection System DECE1C, A 17 DTJ, A 17 DTR, Z 17 DTJ, Z 17 DTR
- Check the following data list parameters:
The check of the following system is only necessary, if the outside temperature is less than 0 °C (32 °F).
Actuator Tests
- Perform the following Actuator Tests:
Glow Time Relay Test
- If the test fails, perform the following test step:
After successful test/fault repair proceed to the next test step
|
