Test
|
Work Order Description
|
Nominal Value
|
T001
|
Check: Interruption of Signal Circuit
|
- Ignition OFF
- Disconnect wiring harness connector from:
L2A Injection Valve - Cylinder 1
- Remove electrical component from socket:
K10_X125 Relay - Fuel Pump
- Connect fused jumper wire to:
K10_X125 Relay - Fuel Pump Socket Terminal 87 & Battery voltage
- Measure voltage between the following terminals:
L2A Injection Valve - Cylinder 1 Wiring harness connector (wiring harness side) terminal 1 & Ground
|
greater than 11 V
|
|
|
T002
|
Check: Short to Voltage of Signal Circuit
|
- Remove fused jumper wire
- Disconnect wiring harness connector from:
M3 Motor - Radiator Fan and A84 Control Unit - Engine (Wiring Harness Connector XC1 )
- Ignition ON
- Measure voltage between the following terminals:
L2A Injection Valve - Cylinder 1 Wiring harness connector (wiring harness side) terminal 2 & Ground
|
less than 0.3 V
|
|
|
T003
|
Check: Short to Ground of Signal Circuit
|
- Ignition OFF
- Measure resistance between the following terminals:
L2A Injection Valve - Cylinder 1 Wiring harness connector (wiring harness side) terminal 2 & Ground
|
greater than 500 kOhm
|
|
|
T004
|
Check: Component
|
- Measure resistance between the following terminals:
L2A Injection Valve - Cylinder 1 Wiring harness connector (component side) terminal 1 & L2A Injection Valve - Cylinder 1 Wiring harness connector (component side) terminal 2
|
10 ... 14 Ohm
|
|
|