Engine does not start, starter runs normal
|
Perform the following tests in the given order until a defect is found.
- Select the following Functional System on the diagnostic tester:
Motronic 7.6.2, Z 16 LET
Check the following data list parameters:
-
- Perform the following Actuator Tests:
Function Checks
After successful test/fault repair proceed to the next test step
|
Vehicle with manual transmission:
Engine does not start, starter slow / does not turn
|
The following test steps must be performed in the given order. If a fault is found in one test step, the subsequent test steps can be skipped.
Fuses
- Check the following fuses for proper operation:
FE18 Fuse
- If fuse FE18 is defective:
Data List
- Select the following Functional System on the diagnostic tester:
IPC (Instrument)
- Check the following data list parameters:
Perform the following troubleshooting:
After successful test/fault repair proceed to the next test step
|