Test
|
Work Order Description
|
Nominal Value
|
T001
|
Check: Interruption of Voltage Supply Circuit
|
- Ignition OFF
- Remove electrical component from socket:
K2_X125 Relay - Engine Control Unit
- Disconnect wiring harness connector from:
Y123 Solenoid Valve - Tank Ventilation Connect fused jumper wire to: K2_X125 Relay - Engine Control Unit Socket Terminal 87 & Battery voltage
- Measure voltage between the following terminals:
Y123 Solenoid Valve - Tank Ventilation Wiring harness connector (wiring harness side) terminal 1 & Ground
|
greater than 11 V
|
|
|
T002
|
Check: Short to Voltage of Voltage Supply Circuit
|
- Disconnect wiring harness connector from:
A84 Control Unit - Engine
- Ignition ON
- Measure voltage between the following terminals:
Y123 Solenoid Valve - Tank Ventilation Wiring harness connector (wiring harness side) terminal 2 & Ground
|
less than 0.3 V
|
|
|
T003
|
Check: Interruption of Signal Circuit
|
- Ignition OFF
- Measure resistance between the following terminals:
A84 Control Unit - Engine Wiring harness connector (wiring harness side) terminal 33 (XC99) & Y123 Solenoid Valve - Tank Ventilation Wiring harness connector (wiring harness side) terminal 2
|
less than 5 Ohm
|
|
|
T004
|
Check: Component
|
- Connect wiring harness connector to:
Y123 Solenoid Valve - Tank Ventilation
- Ground the following terminal briefly several times:
A84 Control Unit - Engine Wiring harness connector (wiring harness side) terminal 33 (XC99)
|
Clicking noise from following component:
Y123 Solenoid Valve - Tank Ventilation
|
|