Accumulator Pressure Sensor, Replace
Warning: When
working on the Common Rail system, wait for one minute after
switching off the engine. The system reduces the pressure
automatically.
Important: When
working on the fuel system, cleanliness is vital as even very small
particles of dirt can lead to faults in engine operation or in the
fuel system. Seal open fuel connections with suitable sealing plugs
1) . Sealing plugs must only be used once.
Remove
2. |
Disconnect battery
• |
Detach ground connection from ground terminal
|
|
4. |
Place collecting basin underneath.
|
5. |
Remove accumulator pressure sensor (1)
• |
Disconnect wiring harness connector.
|
• |
Unscrew pressure sensor
|
|
|
|
Install
6. |
Install accumulator pressure sensor
• |
Tighten pressure sensor 70 Nm
|
• |
Connect wiring harness plug
|
|
8. |
Connect battery
• |
Attach ground connection to ground terminal
|
|
9. |
Program volatile memories
|
1 ) Protective caps are available in the Opel parts
catalogue under catalogue number: 45 06 154 / part number: 9201697
|