Main Housing, Replace (AF17)
Note: See current
valid EPC for parts required for repair.
Remove
4. |
Remove differential (1)
|
5. |
Remove parking lock (3)
|
6. |
Remove intermediate gear (driven) (2)
|
7. |
Remove fluid strainer (5)
|
8. |
Remove axial needle bearing (6)
|
9. |
Remove pipeline (8)
Note: If difficult to
move, drive pipeline out carefully with KM-J-7004 and KM-586
Do not damage pipeline.
• |
Remove fastening clamp (7)
|
|
|
|
10. |
Remove assembly, drive shaft with multi-plate clutch C2
|
13. |
Remove multi-plate clutch assembly C1
|
14. |
Remove multi-plate clutch assembly C0 and C3
|
15. |
Remove rear ring gear assembly with freewheel F0
|
16. |
Remove front ring gear assembly with freewheel F1 and planetary
carrier
|
17. |
Remove multi-disc brake assembly B2
|
18. |
Remove intermediate gear (driving)
|
19. |
Remove brake band piston B1
|
20. |
Remove transmission input speed sensor (1)
|
21. |
Remove transmission output speed sensor (2)
|
23. |
Remove transmission wiring harness (3)
|
|
|
Install
24. |
Install wiring harness for transmission 7 Nm
|
25. |
Install 8x plug 8 Nm
Note: Use new seal
rings.
|
26. |
Install transmission output speed sensor (2)
Note: Use new seal
rings.
|
27. |
Install transmission input speed sensor (1)
Note: Use new seal
rings.
|
|
|
28. |
Install brake band piston B1
|
29. |
Install fluid strainer
|
30. |
Install axial needle bearing assembly
|
32. |
Install intermediate gear (driving)
|
33. |
Install multi-disc brake assembly B2
|
34. |
Install front ring gear assembly with freewheel F1 and
planetary carrier
|
35. |
Install rear ring gear assembly with freewheel F0
|
36. |
Install multi-plate clutch assembly C0 and C3
|
37. |
Install multi-plate clutch assembly C1
|
39. |
Install brake band B1
|
40. |
Install assembly, drive shaft with multi-plate clutch C2
|
42. |
Install intermediate gear (driven)
|
|