Replace windscreen wiper motor with linkage -
LHD
Remove
1. |
Remove windscreen trim seal (1)
|
2. |
Remove wiper arms (2)
• |
Pull 2x windscreen wiper arm from shaft with KM-6166-20/30
|
|
|
|
|
3. |
Remove windscreen casing (1)
• |
Lift windscreen casing in vicinity of front wall
|
Important: Carefully unclip clips
from inside from upper front wall mounting
|
• |
Undo 5x clip (3)
|
• |
Remove hose for screen wash system (2)
|
|
|
4. |
Remove wiper linkage with motor
• |
Disconnect wiring harness plug (2)
|
|
|
|
Install
5. |
Install wiper linkage with motor
• |
Connect wiring harness plug
|
|
6. |
Attach windscreen trim
• |
Fit hose for screen wash system
|
|
7. |
Install screen wiper arms
• |
Place 2x windscreen wiper arm on shaft
Note: Ensure correct
installation position of screen wiper arms!
|
|
8. |
Fit windscreen trim seal
|
9. |
Windscreen Wiper Arms, Basic Adjustment
|
|