DTC P0610 (LUJ)
Diagnostic Instructions
DTC Descriptor
DTC P0610 00: Control Module Vehicle Options
Incorrect |
Circuit/System Description
This diagnostic verifies that the engine control module (ECM) is
programmed for the correct vehicle options.
Conditions for Running the DTC
• |
The ignition voltage is
between 8-16 V. |
Conditions for Setting the DTC
The ECM detects that programming for vehicle options is
incorrect.
Action Taken When the DTC Sets
• |
DTC P0610 00 is a Type C
DTC. |
• |
The service vehicle soon
indicator will illuminate. |
Conditions for Clearing the DTC
DTC P0610 00 is a Type C DTC.
Reference Information
Schematic Reference
Engine Controls Schematics
Connector End View Reference
Component Connector End Views
Electrical Information Reference
DTC Type Reference
Powertrain Diagnostic Trouble Code (DTC) Type Definitions
Scan Tool Reference
Control Module References
Circuit/System Verification
1. |
Engine running, observe the
DTC information with a scan tool. DTC P0610 00 should not
set. |
2. |
Operate the vehicle within the
conditions for running the DTC to verify the DTC does not reset.
You may also operate the vehicle within the conditions that you
observed from the freeze frame/failure records data. |
Circuit/System Testing
2. |
Clear DTCs with a scan
tool. |
3. |
Ignition OFF, allow the K20
Engine Control Module to completely power down. |
4. |
Operate the vehicle within the
conditions for running DTC P0610 00. |
5. |
Verify with a scan tool that
DTC P0610 00 has not reset. |
⇒ |
If DTC P0610 00 does reset, replace the K20 Engine
Control Module. |
Repair Instructions
Perform the
Diagnostic Repair Verification after completing the diagnostic
procedure.
Control Module References for ECM replacement, setup and
programming
|